[CUWiN-Dev] G and A and realworld throughput
listsubs0506
listsubs0506 at comcast.net
Fri Jul 15 20:42:22 CDT 2005
>Stelios Valavanis wrote:
>shall i assume that the cuwin is no different and that this would be
>applicable to cuwin mesh?
I'm far from an expert in these matters and look forward this weekend to
reading some of the material that David referred us to. But I would
suggest you not count on any better results in the field than might be
suggested by the Kumar article. And it could well be worse. You'll see
here some stats on a quick test I helped with in Boston:
http://pdos.csail.mit.edu/roofnet/doku.php?id=april2
That has encouraged me to think that there and at similar sites, we
should aim to use directional antennas on the perimeter as part of
trying to minimize hops and perhaps that's something that could be
helpful in your situation. Just this past week we've started doing more
systematic testing using the Netgear routers so I may have a better
understanding within the next few weeks, though they don't lend
themselves to swapping antennas (we'll supplement with at least a couple
of outdoor boxes that do). Perhaps if you were to describe in more
detail the architecture in regard to which nodes would be expected to
communicate with which other nodes, David or others on this list could
give you a more accurate estimate.
Given this description of yours: "here in chicago we're about to deploy
a 20 node cuwin mesh backhaul network with cisco APs shooting out to the
end users. the ciscos are getting donated fyi but i did get the metrix
kits with dual radios for when cuwin can do dual radio" I think you'd
be very intested in the recent segment on Wireless Tech Radio featuring
MetroFi founder and CEO Chuck Haas especially from minutes 7:18 to
10:00. You can find the entire MetroFi segment highlighted down towards
the bottom of the page here:http://www.wirelesstechradio.com/
MetroFi use a two radio backhaul system with 45 degree sector antennas
and it sounds as if the backhaul radios tend to lock in to a particular
path but are aware of each others' location and able to reroute if a
backhaul node fails. I'd be interested if anyone knows more about the
software that MetroFi uses for that purpose. It seems like the kind of
thing that might best suit your purpose at the moment, Stel, if it or
something similar is available.
Steve Ronan
More information about the CU-Wireless-Dev
mailing list