[Commotion-dev] meshing over ethernet
Chris Ritzo
critzo at opentechinstitute.org
Mon Jun 30 06:22:46 EDT 2014
This sounds like the same issue we encountered in a recent mesh
deployment at AMC. It may be a firewall zone bug specific to meshing
over ethernet. This may help diagnose/fix:
https://github.com/opentechinstitute/commotion-router/issues/128
On Mon 30 Jun 2014 04:23:56 AM EDT, miles wrote:
>
>
> I'm having problems with the following mesh
> Subnet -> wifi -> Device F ->ethernet link -> Device C -> wifi link -> Device A or Device E
>
> C gets updates from F, A and E. Route table looks good & it can connect to Subnet and the other routers.
>
> F only gets routes for C.
> A gets routes only for E.
> E gets routes only for A
>
> all hosts are using the same serval keyring & signing key. All are rc1.1r2.
> Each node has a wired ether interface and a mesh interface. The wired interface is unplugged except for nodes F & C.
>
> I suspect that part of my problem may be with HNA.
> https://commotionwireless.net/docs/cck/installing-configuring/common-configuration/ suggests disabling HNA for both devices in "Two wireless devices meshed over an ethernet connection". This seems counter intuitive. Don't I still want to announce both AP subnets?
>
> Any suggestions where I should look for problems?
>
>
> _______________________________________________
> Commotion-dev mailing list
> Commotion-dev at lists.chambana.net
> https://lists.chambana.net/mailman/listinfo/commotion-dev
--
---
Chris Ritzo
Senior Technologist, Open Technology Institute
New America Foundation
1899 L St. NW Suite 400
Washington, D.C 20036
202-596-3406
---
More information about the Commotion-dev
mailing list