[Commotion-dev] meshing over ethernet
miles
miles at tenhand.com
Mon Jun 30 04:23:56 EDT 2014
I'm having problems with the following mesh
Subnet -> wifi -> Device F ->ethernet link -> Device C -> wifi link -> Device A or Device E
C gets updates from F, A and E. Route table looks good & it can connect to Subnet and the other routers.
F only gets routes for C.
A gets routes only for E.
E gets routes only for A
all hosts are using the same serval keyring & signing key. All are rc1.1r2.
Each node has a wired ether interface and a mesh interface. The wired interface is unplugged except for nodes F & C.
I suspect that part of my problem may be with HNA.
https://commotionwireless.net/docs/cck/installing-configuring/common-configuration/ suggests disabling HNA for both devices in "Two wireless devices meshed over an ethernet connection". This seems counter intuitive. Don't I still want to announce both AP subnets?
Any suggestions where I should look for problems?
More information about the Commotion-dev
mailing list