[Imc-makerspace] QR and GML Stenciler

[Stewart Dickson]

Yes.  Only limited by size, I think.

-Stewart

On 7/21/11 2:56 PM, Bill Hannaford wrote:
> CUC Fab Lab would be equipped to deploy these, no?
>
> "We present QR_STENCILER, a free, fully-automated utility which
> converts QR codes into vector-based stencil patterns suitable
> for laser-cutting.   Additionally, we present QR_HOBO_CODES, a
> series of one hundred QR stencil designs which, covertly marked
> in urban spaces, may be used to warn people about danger or clue
> them into good situations... QR_STENCILER has been tested in
> MacOSX 10.6.8."
>
> http://fffff.at/qr-stenciler-and-qr-hobo-codes/
>
> "We announce the release of GMLStenciler, an open-source software
> project for converting Graffiti Markup Language (GML) drawings
> into vector-art stencils suitable for laser cutting. This free
> tool solves the problem of transforming GML’s widthless linear
> strokes into adjustably-thickened stencil patterns with
> automatically bridged islands. GMLStenciler is built in
> openFrameworks, an open-source C++ toolkit 
for creative coding;
> it can be downloaded below (with complete source code) for
> Windows and Mac OSX."
>
> http://www.flong.com/blog/2010/gml-stenciler/
> _______________________________________________
> Imc-makerspace mailing list
> Imc-makerspace at lists.chambana.net
> http://lists.chambana.net/mailman/listinfo/imc-makerspace