[Commotion-discuss] Resetting commotion nodes to UBNT software

[Anthony S]

Thanks Ben. We are in Recovery Mode.
Because the Commotion routers were previously out in the field, many of
them have had their IP addresses changed. I assume you write 192.168.1.20
because that should be the default IP of the router, but is there another
reason that that should be the IP? (when we looked in our control panel to
find the IP is was 10.8.216.1)
t

On Wed, Mar 18, 2015 at 3:53 PM, Ben West <ben at gowasabi.net> wrote:

> The only way I know to flash UBNT devices from OpenWRT back to their stock
> firmware is to put them in recovery mode via the reset button on the radio
> itself, or using the reset button on the 1amp POE injector. OpenWRT itself
> can't flash them back to stock firmware.
>
> Once in recovery mode, the radio should respond to TFTP at IP address
> 192.168.1.20.
> On Mar 18, 2015 2:47 PM, "Anthony S" <tony at rhicenter.org> wrote:
>
>> We have been trying to restore the Ubiquiti settings/software on a
>> current Commotion node.
>> We have tried TFTP through a GUI, and the command line. We insured that
>> we knew the IP address of the router, and set our computer to be on the
>> same network.
>> But, it wont work. We either are returned the message "Host is down" or
>> "No route to host"
>> Anyone have thoughts on how to make this work?
>> thanks
>> tony
>>
>> --
>>
>> *Anthony SchlossDirector of Community Initiatives*
>> www.rhicenter.org
>>
>>
>>
>> _______________________________________________
>> Commotion-discuss mailing list
>> Commotion-discuss at lists.chambana.net
>> https://lists.chambana.net/mailman/listinfo/commotion-discuss
>>
>>


-- 

*Anthony SchlossDirector of Community Initiatives*
www.rhicenter.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.chambana.net/pipermail/commotion-discuss/attachments/20150318/00e04455/attachment.html>